Remove The Microphone Rubbers; Remove The Edp Cable; Remove The Camera - Lenovo V14 Gen 4 i Hardware Maintenance Manual

EDP cable
Removable tape

Remove the camera

Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 69
"Remove the LCD bezel" on page 71
"Remove the LCD panel" on page 72
"Remove the microphone rubbers" on page 73
Step 1. Disconnect the EDP cable from the camera board and then remove the camera.
Figure 75. Disconnect the EDP cable from the camera board and then remove the camera
Go to
https://support.lenovo.com/partslookup
replacement parts:
Camera
Removable tape
Remove the LCD cover
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 69
"Remove the LCD bezel" on page 71
"Remove the hinges" on page 71
"Remove the LCD panel" on page 72
"Remove the microphone rubbers" on page 73
"Remove the EDP cable" on page 74
"Remove the camera" on page 75
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
75