Remove The Solid-State Drive (Ssd) Module - Lenovo 16IRU8 Hardware Maintenance Manual

Screw specifications
M2 x L3.5
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 60
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw. Remove the SSD and SSD bracket by pulling it away from the slot.
Figure 51. Remove the SSD and SSD bracket
Screw specifications
M2 x L2
Step 3. Remove one screw then remove the SSD bracket.
Figure 52. Remove the SSD bracket
Screw specifications
Step 4. Remove the SSD thermal pad.
62
Hardware Maintenance Manual
Number of screws
3
to look up the Lenovo part number of the following replacement
Number of screws
1
Number of screws
1