Remove The Solid-State Drive (Ssd) Stand Off - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Figure 79. Remove one screw then remove the SSD by pulling it away from the slot
Screw specifications
M2 x L2.8
Step 3. Remove the SSD thermal pad.
Figure 80. Remove the SSD thermal pad
Go to
https://support.lenovo.com/partslookup
replacement parts:
SSD
SSD thermal pad

Remove the solid-state drive (SSD) stand off

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 77
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw then remove the SSD by pulling it away from the slot.
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
79