Remove The Heat Sink (For Lenovo V14 G4 Amn) - Lenovo V14 Gen 4 i Hardware Maintenance Manual

Hide thumbs Also See for V14 Gen 4 i:
Table of Contents

Advertisement

Figure 17. Remove the Wi-Fi card
Screw specifications
M2 x L2.8
Go to
https://support.lenovo.com/partslookup
part:
Wi-Fi card

Remove the heat sink (for Lenovo V14 G4 AMN)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 38
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Loosen four screws and then remove the heat sink.
Figure 18. Remove the heat sink
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Number of screws
1
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
43

Advertisement

Table of Contents
loading

Table of Contents