Table of Contents
Advertisement
CALCulate[1|2|3|4]:MARKer:OFFSet:ZERO
Changes the offset marker's X and Y values to those of the marker.
Command Syntax:
CALCulate[1|2|3|4]:MARKer:OFFSet:ZERO
Example Statements:
OUTPUT 719;"calculate4:mark:offs:zero"
OUTPUT 719;"Calc:Marker:Offs:Zero"
Attribute Summary:
Synchronization Required:
Preset State:
SCPI Compliance:
Description:
This command moves the offset marker to the same position as the relative marker, setting the
offset value to zero.
If either the main or offset markers are turned off, this command turns them on. Therefore, it is
not necessary to turn them on prior to zeroing.
If no number is given in the CALC branch, "1" is assumed.
Related Commands:
To position the relative marker, use CALC:MARK:X.
To read the relative marker (offset) values, use CALC:MARK:X:REL? and
CALC:MARK:Y:REL?.
To position the offset marker at a position other than that of the main marker, use
CALC:MARK:OFFSET:X and CALC:MARK:OFFSET:Y.
no
not applicable
instrument-specific
Command Reference
command
83
Advertisement
Table of Contents
