Table of Contents
Advertisement
Appendix A
Error Messages
Error
Error Message
Number
-221
"Scalar instrument mode is not available when receiver mode is IF section (ch1 + j*ch2)"
-221
"Select DC coupling on both input channels to avoid IQ offset errors."
-221
"Source Level is 0 Volts. Measurement aborted."
-221
"The LAN port cannot be changed while the X11 display is on."
-221
"Type of unit setting does not match the unit query."
-222
"Data out of range"
-224
"Illegal parameter value"
-224
"REAL format length is only 32 and 64."
-230
"Trace contains invalid data."
-240
"%s Please see your Service Guide for instructions."
-240
"10 MHz reference loop unlocked in RF section."
-240
"600 MHz loop unlocked in RF section."
-240
"Error when writing Cal Data to Flash memory in RF section."
-240
"Failure of communication link with RF section."
-240
"RF section external reference not detected."
-241
"Channel 2 is not available."
-241
"Option 1D4 Source is not installed."
-250
"Bad disk"
-250
"Bad mass storage parameter"
-250
"Can't name split file. Enter a shorter filename."
-250
"Disk file/unit may be corrupt."
-250
"External disk is not SS/80 protocol."
-250
"External disk is not responding."
-250
"External system controller detected. Change to system controller not allowed."
-250
"File does not contain a capture."
-250
"File does not contain a state."
-250
"File does not contain a trace."
-250
"File does not contain a waterfall/spectrogram."
-250
"File does not contain math function definitions."
-250
"File system error"
472
Advertisement
Table of Contents
