Agilent Technologies 89400 Series Command Reference Manual page 267

set command is a list of values for the variable or array to be assigned. This list may either be
ASCII numbers separated by commas or a definite or indefinite block. The response is generated
in the current format (specified by the FORMat[:DATA] command).
When an array is loaded with this command, values in the <block> parameter are loaded into the
st th
1 through n elements of the array (where n is number of values in the block).
Related Commands:
To specify the active program, use PROG:NAME.
To load string variables, use PROG:STR.
Command Reference
257