Table of Contents
Advertisement
Appendix A
Error Messages
Error
Error Message
Number
-200
"Program memory re-size is not allowed while recording enabled."
-200
"Program variable access not allowed while recording enabled."
-200
"Receiver must be 0-10 MHz to measure from capture."
-200
"Receiver must be 2-1800 MHz to measure from capture."
-200
"Receiver must be 2-2650 MHz to measure from capture."
-200
"Receiver must be External to measure from capture."
-200
"Recording mode canceled because: %s"
-200
"Remote X11 display connection closed"
-200
"Result length truncated to fit within search length."
-200
"Save/recall program is not allowed during power-on calibration."
-200
"Save/recall program is not allowed while recording enabled."
-200
"Search length or result length adjusted due to insufficient Time Capture RAM. For details, see online help for the
[search length] softkey."
"Search length, result length or points/symbol adjusted See [System Utility] → [memory usage] to set the 'max time
-200
points' limit and/or 'max span/symR' ratio."
"Search length, result length or points/symbol adjusted See [System Utility] → [memory usage] to set the 'max time
-200
points' limit."
-200
"Search target not found."
"Span adjusted. Maximum span limited by symbol rate and maximum span/symbol rate ratio. See [System Utility] →
-200
[memory usage] to set the 'max span/symR' ratio."
-200
"Span adjusted. Minimum span limited by symbol rate."
-200
"Sync offset adjusted. Sync offset limited to maintain sync pattern length within search length."
-200
"Temporary math buffer(s) unavailable. Math expression too complicated. Simplify math expression in terms of other
math functions."
"Temporary math buffer(s) unavailable. See [System Utility] → [memory usage]."
-200
-200
"The Agilent Technologies Instrument BASIC editor has been disabled."
-200
"The custom application is not compatible with the analyzer's main firmware. Please contact your local Agilent
Technologies Service Center for firmware upgrade information."
-200
"This parameter is set at the factory."
-200
"Trace does not contain valid waterfall/spectrogram data."
-200
"Unable to open remote display"
-200
"Unsupported operation"
470
Advertisement
Table of Contents
