Table of Contents
Advertisement
1. Insert the three tabs on the bezel into the corresponding holes in the front of the server.
2. Rotate the bezel to the server until it locks securely into place.
3. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Removing the lower bezel
This procedure applies only to the 5U server model with hot-swap power supplies (Model name: 2582-F4x).
To access the hard disk drives on the 5U server model with hot-swap power supplies (Model name: 2582-
F4x), you must first remove the lower bezel.
1. Read the safety information in
2. If you are replacing a non-hot-swap component, turn off the server and all attached devices; then,
disconnect all power cords and external cables.
3. Press the blue-colored release button on the right side of the lower bezel and rotate the lower bezel
downward to disengage from the chassis.
System x3100 M4 Installation and Service Guide
150
"Safety" on page v
and
"Installation guidelines" on page
30.
Advertisement
Table of Contents
Troubleshooting
