Removing The Hot-Swap Power Supply - Lenovo System x3100 M4 Installation And Service Manual

4. Install the screws that secure the power supply to the chassis.
5. Install the air duct.
6. Install the side cover (see
7. Stand the server back up in its vertical position.
8. Install the bezel (see
9. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.

Removing the hot-swap power supply

This procedure applies only to the 5U server model with hot-swap power supplies (Model name: 2582-F4x).
When you remove or install a hot-swap power supply, observe the following precautions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Statement 8
System x3100 M4 Installation and Service Guide
216
"Replacing the side cover" on page
"Replacing the bezel" on page
147).
149).