Removing The Bezel - Lenovo System x3750 M4 Installation And Service Manual

Step 3. Slide the cover toward the front of the server; then, press down on the cover release latch until it
clicks into place.
Step 4. Slide the server back into the rack cabinet until it latches.
Step 5. Reconnect the external cables and power cords.

Removing the bezel

Use this information to remove the bezel.
To remove the bezel, complete the following steps:
Step 1. Read the safety information and installation guidelines, see "Safety" on page v and "Installation
guidelines" on page 38.
Step 2. Turn off the server (see "Turning off the server" on page 23) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Slide the server out of the rack.
Step 4. Remove the screws from the bezel with a Torx screwdriver.
Cover release
latch
Chapter 6
Top cover
.
Removing and replacing components
217