Replacing The Hard Disk Drive Cage - Lenovo System x3100 M4 Installation And Service Manual

8. Remove the simple-swap backplate (see
9. Press and hold the drive cage release latches.
10. Carefully pull the hard disk drive cage and the cables out of the opening in the chassis.
11. If you are instructed to return the drive cage, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Replacing the hard disk drive cage

This procedure applies only to 4U server models with non-hot-swap power supplies.
To install the hard disk drive cage on 4U server models with non-hot-swap power supplies, complete the
following steps.
1. Read the safety information in
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Remove the bezel (see
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see
6. Remove the air duct.
7. Press the hard disk drive cage in until the release latches click into place.
"Removing the simple-swap backplate" on page
Cage release latches
"Safety" on page v
"Removing the bezel" on page
"Removing the side cover" on page
and "Installation guidelines" on page
148).
145).
.
Chapter 6 Removing and replacing components
192).
30.
211