Removing The Security Bezel - Lenovo System x3550 M5 Installation And Service Manual

Step 7. Connect the COM port bracket cable to the system board.
Figure 186. COM port bracket cable routing
Step 8. Reinstall the cover (see "Replacing the cover" on page 120).
Step 9. Slide the server into the rack.
Step 10. Reconnect the power cords and any cables that you removed.
Step 11. Turn on the peripheral devices and the server.

Removing the security bezel

Use this information to remove the security bezel.
Note: Installation of the security bezel is to limit access for increased security.
To remove the security bezel, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. If necessary, turn off the server and peripheral devices and disconnect the power cords and all
external cables.
260
Lenovo System x3550 M5 Installation and Service Guide
COM port cable connector