Table of Contents
Advertisement
To install the left-side server cover, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover-side facing up.
Step 2.
Set the bottom edge of the left-side cover on the bottom ledge of the server.
Step 3.
Rotate the top edge of the cover toward the server and press the cover release latch down until it
clicks into place.
Figure 103. Set the bottom edge of the left-side cover
Step 4.
Lock the cover, using the key that comes with the server.
Removing the bezel
Use this information to remove the bezel.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove the bezel, complete the following steps.
Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side cover,
it locks both the cover and the bezel.
Step 1.
Unlock the left-side cover.
Step 2.
From the top section of the bezel door, turn the tab up to unlock the bezel door
184
System x3500 M5 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
