Lenovo 5457 Installation And Service Manual page 63

To install a tape drive on 4U server models with non-hot-swap power supplies, complete the following steps.
For the 5U server model with hot-swap power supplies, please see the next sub-section.
1. Read the safety information in
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Remove the bezel (see
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see
6. Remove the air baffle (see
7. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that comes with the drive.
9. Stand the server back up in its vertical position.
10. Remove the filler from the drive cage, if any is present.
11. Remove the drive retainer clip from the side of the drive cage of bay 1 or bay 2. Slide the drive retainer
clip to the front to remove it from the drive cage; then, snap the drive retainer clip into the screw holes on
the side of the drive.
12. Push the drive into the bay.
Note: A tape drive can only be installed in bay 1 or bay 2.
Figure 33. Tape drive installation for 4U server model with non-hot-swap power supplies
13. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
"Safety" on page v
"Removing the bezel" on page
"Removing the side cover" on page
"Removing the air baffle" on page
Drive retainer clip
and "Installation guidelines" on page
37).
34).
36).
EMC filler
Tape drive
Chapter 2
31.
.
Installing optional devices
51