Lenovo 5457 Installation And Service Manual page 227

4. Unfasten the retention clips that secure the hard disk drive fan duct cable and then disconnect the hard
disk drive fan duct cable from the system board.The following illustration is for 5U server models with
2.5" hot swap hard disk drives installed.
Figure 124. 2.5" hard disk drive fan duct cable removal for 5U server model with hot-swap power supplies
The following illustration is for 5U server models with 3.5" hot swap hard disk drives installed.
Figure 125. 3.5" hard disk drive fan duct cable removal for 5U server model with hot-swap power supplies
5. Grasp the hard disk drive fan duct by the blue point and pull up to lift it out of the chassis. The following
illustration is for 5U server models with 2.5" hot swap hard disk drives installed.
Fan power cable
Fan power cable
.
Chapter 6 Removing and replacing components
215