Lenovo 5457 Installation And Service Manual page 233

USB embedded
hypervisor flash
device connector
Figure 134. USB hypervisor flash device connector location on system board for 5U server model with hot-swap
power supplies
7. Slide the lockbar on the flash device connector to the unlocked position and pull the USB flash device
out of the connector.
USB embedded
hypervisor
flash device
Figure 135. USB hypervisor flash device removal from system board for 5U server model with hot-swap power
supplies
8. If you are instructed to return the hypervisor memory key, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Note: You must configure the server not to look for the hypervisor USB drive. See
server" on page 86
Replacing the USB embedded hypervisor flash device
Use this information to replace a USB embedded hypervisor flash device.
To install a USB embedded hypervisor flash device on 4U server models with non-hot-swap power supplies,
complete the following steps. For the 5U server model with hot-swap power supplies, please see the next
sub-section.
for information about disabling hypervisor support.
Lockbar
.
Chapter 6 Removing and replacing components
"Configuring the
221