Lenovo 5457 Installation And Service Manual page 234

1. Read the safety information in
2. Locate the USB embedded hypervisor flash device connector on the system board.
USB embedded
hypervisor flash
device connector
Figure 136. USB hypervisor flash device connector location on system board for 4U server model with non-hot-swap
power supplies
3. Align the USB flash device with the connector on the system board and push it into the connector until it
is firmly seated.
4. Slide the lockbar toward the riser-card assembly to the locked position until it is seated firmly.
USB embedded
hypervisor
flash device
Figure 137. USB hypervisor flash device installation for 4U server model with non-hot-swap power supplies
5. Install the air baffle (see
6. Install the side cover (see
7. Stand the server back up in its vertical position.
8. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Lenovo System x3100 M5 Installation and Service Guide
222
"Safety" on page v
"Replacing the air baffle" on page
"Replacing the side cover" on page
and "Installation guidelines" on page
Lockbar
178).
175).
31.