Lenovo 5457 Installation And Service Manual page 203

Hard disk cage
Figure 98. Hard disk drive cage installation for 5U server model with hot-swap power supplies
3. Install the screws to secure the hard disk drive cage into the chassis.
Screws
Figure 99. Hard disk drive cage screw installation for 5U server model with hot-swap power supplies
4. Connect the power, signal and configuration cables to the hard disk drive backplane (for details
regarding the cabling, see
5. Press and hold the retaining tab on the side of the cage; then, rotate the drive cage into the chassis until
it locks into place.
Hinge pin
Pin hole
"Replacing the hot-swap hard disk drive backplane" on page
.
Chapter 6 Removing and replacing components
233).
191