Lenovo 5457 Installation And Service Manual page 64

14. Connect one end of the applicable signal cable into the rear of the drive and make sure that the other
end of this cable is connected into the applicable connector on the system board.
15. Route the signal cable so that it does not block the airflow to the rear of the drives or over the
microprocessor and dual inline memory modules (DIMMs).
If you have other devices to install, do so now. Otherwise, go to
To install a tape drive on the 5U server model with hot-swap power supplies, complete the following steps.
For 4U server models with non-hot-swap power supplies, please see the above sub-section.
1. Read the safety information in
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Unlock and remove the side cover (see
4. Remove the lower bezel (see
5. Remove the upper bezel (see
6. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that comes with the drive.
8. Remove the filler from the drive cage, if any is present.
9. Slide the drive retainer clip to the front to remove it from the drive cage of bay 2; then, snap the drive
retainer clip into the screw holes on the side of the drive.
Drive retainer clip
Figure 34. Drive retainer clip installation for 5U server model with hot-swap power supplies
10. Push the drive into the bay.
Lenovo System x3100 M5 Installation and Service Guide
52
"Safety" on page v and
"Removing the side cover" on page
"Removing the lower bezel" on page
"Removing the upper bezel" on page
"Completing the installation" on page
"Installation guidelines" on page
34).
39).
39).
75.
31.