Lenovo 5457 Installation And Service Manual page 230

3. Connect the hard disk drive fan duct cable to the system board (see
on page 27 for the location of the fan assembly connector).
Attention: Remember to insert the hard disk drive fan duct cable into the relevant retention clips.
The following illustration is for 5U server models with 2.5" hot swap hard disk drives installed.
Figure 130. 2.5" hard disk drive fan duct cable installation for 5U server model with hot-swap power supplies
The following illustration is for 5U server models with 3.5" hot swap hard disk drives installed.
Figure 131. 3.5" hard disk drive fan duct cable installation for 5U server model with hot-swap power supplies
4. Stand the server back up in its vertical position.
5. Install and lock the side cover (see
Lenovo System x3100 M5 Installation and Service Guide
218
Fan power cable
Fan power cable
"Replacing the side cover" on page
"System-board internal connectors"
175).