Lenovo 5457 Installation And Service Manual page 549

1. Check IMM logs for communication errors and resolve.
2. Reseat system
3. If problem persists escalate to the next level of support
• S.3030007: [S.3030007] A firmware fault has been detected in the UEFI image.
[S.3030007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
• S.3040007: [S.3040007] A firmware fault has been detected in the UEFI image.
[S.3040007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
• S.3050007: [S.3050007] A firmware fault has been detected in the UEFI image.
[S.3050007] A firmware fault has been detected in the UEFI image.
Severity: Error
User Response:
Complete the following steps:
1. Check IBM Support website for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
• S.3058004: [S.3058004] A Three Strike boot failure has occurred. The system has booted with
default UEFI settings.
[S.3058004] A Three Strike boot failure has occurred. The system has booted with default UEFI settings.
Severity: Error
User Response:
Complete the following steps:
1. This event resets UEFI to the default settings for the next boot. If successful, user is forced into F1
setup. Original UEFI settings are still present.
2. If User did not intentionally trigger the reboots, check logs for probable cause.
Appendix B. UEFI/POST diagnostic codes
537