Lenovo 5457 Installation And Service Manual page 295

Thermal sensor
connector
Figure 209. Thermal sensor board installation for 5U server model with hot-swap power supplies
3. Connect the thermal sensor connector to the system board. Remember to close the cable clips to
secure the cable.
Figure 210. Installing thermal sensor connector to system board for 5U server model with non-hot-swap power
supplies
4. Stand the server back up in its vertical position.
5. Install the upper bezel (see
6. Install the lower bezel (see
7. Install and lock the side cover (see
8. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Cable clips
Thermal sensor
"Replacing the upper bezel" on page
"Replacing the lower bezel" on page
"Replacing the side cover" on page
185).
183).
175).
.
Chapter 6 Removing and replacing components
283