Lenovo 5457 Installation And Service Manual page 198

Bezel clips
Figure 92. Upper bezel installation for 5U server model with hot-swap power supplies
3. Rotate the upper bezel to the left side of the chassis until the bezel clips are aligned with the
corresponding indentations on the left side of the chassis and snap them into place.
4. Unlock and remove the side cover (see
5. Remove the lower bezel (see
6. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Removing the hard disk drive cage
Use this information to remove the hard disk drive cage.
To remove the hard disk drive cage on 4U server models with non-hot-swap power supplies, complete the
following steps. For the 5U server model with hot-swap power supplies, please see the next sub-section.
1. Read the safety information in
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Remove the bezel (see
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see
6. Remove the air baffle (see
7. Remove the simple-swap hard disk drives (see
8. Remove the simple-swap backplate (see
9. Press and hold the drive cage release latches.
Lenovo System x3100 M5 Installation and Service Guide
186
"Replacing the lower bezel" on page
"Replacing the side cover" on page
"Safety" on page v
"Removing the bezel" on page
"Removing the side cover" on page
"Removing the air baffle" on page
"Removing the simple-swap backplate" on page
175).
and "Installation guidelines" on page
180).
173).
177).
"Removing a simple-swap hard disk drive" on page
183).
31.
208).
224).