Fujitsu ULTIMA90 Maintenance Manual page 126

4.10.2 Hex dump
The HEX-DUMP function prints data and commands in hexadecimal characters and abbreviated control
codes. The IBM character set 2 is used for printing (see Appendix E).
The HEX-DUMP function is useful for checking whether your computer is sending the correct
commands to the printer and whether the printer is executing the commands correctly. It is also useful for
debugging software programs.
Procedure
To print hex dumps, make sure that continuous forms paper is loaded into the printer. Then proceed as follows:
1-1. Enter setup mode.(LED)
Press the "AUTO GAP" button and the "HI IMPACT" button simultaneously until the printer beeps. Wait for the
printer to stop printing and check that the following <<FUNCTION>> menu is printed:
2-1. Select the HEX-DUMP function.(LCD)
<< FUNCTION >>
SAVE&END MENU1 MENU2
DUMP V-ALMNT INITIAL
Repeatedly press the "TEAR OFF" or "LOAD" button to position the cursor on the left edge of the aluminum print guide
on HEX-DUMP, then press the
and prints a header and a short help menu
1-2. Enter setup mode(LCD).
Press the SETUP button at offline state. Check that the "SETUP MODE" is displayed on LCD panel.
2-2. Select the HEX-DUMP function(LCD).
Repeatedly press the "
lower layer. And then repeatedly press the "
"SELECT" button. The printer goes online and prints a header and a short help menu.
3. Print the hex dump.
To start hex dump printing, send your file or program to the printer. The printer goes online and prints the hex dump.
Press the "LOAD" button to pause during hex dump printing. To resume hex dump printing, press the button again.
NOTE
When hex dump printing stops, the printer remains online in setup mode (the ONLINE indicator is green).
To print another hex dump, send another file to the printer.
HARDWRE ADJUST
button or the
" or " " button to display "SELFDIAGNOSTIC". And then press the" " button to move
CONFIG GAP-ADJ DEFAULT
button to select the HEX-DUMP function. The printer goes online
" or " " button to display "HEX-DUMP". And then press the
126
LIST SELF-TST HEX-