Fujitsu ULTIMA90 Maintenance Manual page 107

4. Rotate the motor pinion counterclockwise until stopper of SS
gear touch against the stopper stud.
Note Please make sure to rotate gears by motor pinion.
5. Put the "MARK 1" as the base position.
Put the "MARK 1" on the tooth of the gear, and put the mark side
frame at same position.
6. Put the "MARK 2" as the aim for adjustment.
Rotate the motor pinion clockwise to rotate drive gear by 11
teeth. Then put the "MARK 2" to the tooth, which becomes ten
pieces from the "MARK 1".
And then rotate the motor pinion clockwise to rotate drive gear
by 2 teeth.
Figure 4.94 other way to adjust the card guide
Motor pinion
MARK on side frame
MARK 1
This procedure finished 12
107
Screw
Stopper
Stopper
Gear
MARK 2
th
11 from
"MARK 1"
th
teeth