Toro 08781 Operator's Manual page 9

1. Hydraulic line number 1
2. Hydraulic line number 2
3. Hydraulic line number 3
Note:
Install all hydraulic lines loosely first and then
tighten them when everything is installed.
1. Position hydraulic line number 1 into the
machine as shown in
2. Install hydraulic line number 1 to the tee fitting
assembled to the side of the valve
3. Install the hydraulic line number 1 to the upper
male coupler (Figure
1. Tee fitting on the side of
the valve
2. New valve
3. Hydraulic line number 1
Figure 13
4. Hydraulic line number 4
5. Hydraulic line (hose)
number 5
Figure 14.
(Figure
14).
Figure 14
4. Upper male coupler
5. Coupler bracket
4. Position hydraulic line number 2 into the
machine as shown in
5. Install hydraulic line number 2 to the 90-degree
elbow and the top of the new valve
6. Install hydraulic line number 2 to the upper
female coupler
g362945
1. New valve
2. Hydraulic line number 2
7. Loosely install hydraulic line (hose) number 5 to
the lower male coupler
Note:
14).
installed in Procedure 10.
g003608
1. Hydraulic line number 1
2. Coupler bracket
9
Figure 15.
(Figure 15).
Figure 15
3. Upper female coupler
4. Coupler bracket
(Figure
The other end of this hose will be
Figure 16
3. Lower male coupler
4. Hydraulic line (hose)
number 5
(Figure 15).
g362946
16).
g362949