Advertisement
13
Installing the Hydraulic
Fluid and Checking for
Leaks
Parts needed for this procedure:
6.6 L
(7 US
qt) for
Models
Hydraulic fluid
08703
and
08705
Procedure
The hydraulic system capacity for Models 08743
and 08745 is 26.5 L (7 US gallons) and no extra
fluid is needed.
For Models 08703 and 08705, add 6.6 L (7 US qt)
of fluid.
Refer to the Operator's Manual for the correct fluid
to use.
1.
For Models 08703 and 08705, remove the old
dipstick from the hydraulic tank and discard.
Contact your authorized Toro distributor for the
correct dipstick (Part No. 110-8162).
Note:
For Models 08743 and 08745, the correct
dipstick comes with the machine.
2.
Slowly pour approximately 80% of the specified
fluid into the tank.
3.
Insert the dipstick and check the level of the
hydraulic fluid
(Figure
4.
Slowly add the additional fluid to bring it to the
Full mark.
37).
1. Hydraulic-tank cap
2. Dipstick
5.
Start the machine and let it run for 5 minutes.
6.
Check for any leaks in the system with a piece
of cardboard.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
If hydraulic fluid is injected into the skin
it must be surgically removed within a
few hours by a doctor familiar with this
type of injury. Gangrene may result if
this is not done.
• Keep body and hands away from
pin-hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-fluid
hoses and lines are in good condition
and that all hydraulic connections
and fittings are tight before applying
pressure to the hydraulic system.
7.
Install the left front screen to the frame.
8.
Install the front shroud to the frame with 4
flange-head screws.
9.
Install the 4 flange-head screws securing the left
wheel shroud to the frame
10.
Install the left rear tire
18
Figure 37
3. Hydraulic tank
(Figure
38).
(Figure
38).
g003618
Advertisement
