Advertisement
Figure 6
1. Bolt
7.
Remove the 2 screws securing the center
shroud to the frame
retain the shroud.
Figure 7
1. Center shroud
2. Screws
8.
Disconnect the hydraulic lines going to the tank.
9.
Remove the top hydraulic tank bracket from the
machine frame and loosen the 2 brackets on the
side of the frame
and retain the hardware.
2. Rear hitch shield
(Figure
7). Remove and
3. Seat
(Figure
8). Remove the tank
g003838
1. Hydraulic tank
2. Bolt
3. Top bracket
4
Installing Fittings to the
Hydraulic Tank
Parts needed for this procedure:
1
Small 90-degree tee with barb
1
Large 90-degree elbow (threaded both ends)
1
Strainer
Procedure
g003617
Note:
Make sure that all O-rings are lubricated and
properly positioned on all fittings before installation.
Note:
Install all fittings and hydraulic lines loosely first
and then tighten them when everything is installed.
Install the fittings at the angles shown in the figures.
1.
Remove the 2 hydraulic tank plugs from the side
of the tank.
2.
Install the strainer into the hydraulic tank where
the large plug was removed.
3.
Install the large 90-degree elbow into the
strainer.
4.
Install the small 90-degree tee with barb where
the small plug was removed
6
Figure 8
4. Nut
5. Side bracket
6. Washer
(Figure
9).
g003575
Advertisement
