Advertisement
7.
Cover the hose or insert a rag into it so that no
dirt or debris gets into it while installing this kit.
8.
Remove the opposite bolt holding the air-cleaner
strap to the machine frame.
3
Removing the Hydraulic
Reservoir and Shrouds
No Parts Required
Procedure
1.
Drain the hydraulic tank. Refer to the machine
Operator's Manual.
2.
Raise the rear of the machine off the ground
and block up the rear of the machine. Refer to
the machine Operator's Manual under Raising
the Machine.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
3.
Remove the left rear tire.
4.
Remove the 4 flange-head screws securing
the left wheel shroud to the frame
Remove and retain the shroud.
1. Left wheel shroud
2. Flange-head screws
5.
(Figure
4).
1. Flange-head screws
2. Frame
6.
5
Figure 4
Remove the 2 flange-head screws securing
the left front screen to the frame. Remove and
retain the screen.
Figure 5
Remove the 3 bolts securing the rear hitch
shield to the frame.
g003581
3. Tire
4. Nut
g003836
3. Left front screen
Advertisement
