Advertisement
1. Large 90-degree elbow
(install at angle shown)
2. Strainer
3. Remove the large plug.
4. Hydraulic tank
5
Installing the Coupler
Bracket to the Rear Frame
Parts needed for this procedure:
1
Retainer bracket
2
Muffler clamp
1
Hose-retainer bracket
1
Coupler bracket
Procedure
Note:
Install all hydraulic lines loosely first and then
tighten them when everything is installed.
1.
Position the clamps around the round tube of
the rear frame.
2.
Install the hose-retainer bracket and the coupler
bracket to the muffler clamps.
Note:
Do not tighten the nuts at this time. The
coupler bracket needs to be loose to install the
hydraulic lines
(Figure
Figure 9
5. Small 90-degree tee
(install at angle shown)
6. Remove the small plug.
7. 45 degrees
10).
g015917
1. Muffle clamp
2. Muffler bracket
3. Coupler bracket
3.
Temporarily position the coupler bracket on the
round frame tube; refer to
Note:
Place the coupler bracket where the tube
begins to bend.
1. Round frame tube
2. Temporary position for the
coupler bracket
7
Figure 10
4. Retainer bracket
5. Nut
6. Rear frame round tube
Figure
11.
Figure 11
3. Coupler bracket
g003578
g003837
Advertisement
