Table of Contents
Advertisement
Quick Links
Spiker
Sand Pro
Model No. 08755—Serial No. 400000000 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for more information, including
safety tips, training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
1. Model and serial number location
Model No.
Serial No.
© 2021—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
/Infield Pro
Figure 1
Figure 1
Register at www.Toro.com.
®
3040 and 5040 Traction Unit
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Safety
Safety and Instructional
Decals
g353404
1. Warning—do not touch the hot surface.
Original Instructions (EN)
Form No. 3446-130 Rev B
Installation Instructions
Figure 2
Safety-alert symbol
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or missing.
106-5517
*3446-130*
Printed in the USA
All Rights Reserved
g000502
decal106-5517
Advertisement
Table of Contents
Related Manuals for Toro 08755
Summary of Contents for Toro 08755
- Page 1 Whenever you need service, genuine Toro parts, or Safety-alert symbol additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 This manual uses 2 words to highlight information.
-
Page 2: Installation
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Spiker assembly Mount the spiker. – No parts required Adjust the link assembly. – No parts required Finish the setup. Important: Before installing the spiker, the traction unit must be equipped with the Front Weight Kit. -
Page 3: Finishing The Setup
Adjusting the Link Finishing the Setup Assembly No Parts Required No Parts Required Procedure Procedure Before operating the finish grader, review the following materials and save them in an appropriate place: With the attachment mounted and secured on • Parts Catalog the traction unit, raise the attachment. -
Page 4: Operation
Operating Tips Operation • Before beginning the spiking operation with the attachment, find a clear area and practice starting, Inspecting and Cleaning stopping, raising, lowering, and spiking. This the Spiker training period will be beneficial to the operator in gaining confidence in the performance of the spiker. -
Page 5: Maintenance
Maintenance Adjusting the Compression Springs and Ball Joints Greasing the Attachment The springs and ball joints are adjusted at the factory. Adapter However, if new parts are installed or the components are removed for any reason, the spring and ball joint length should be adjusted as shown in Figure If the locking lever on the attachment adapter does... - Page 6 Notes:...
- Page 7 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact your Authorized Toro Service Center.