Advertisement
Figure 19
1. Pump bracket
2. Engine PTO shaft
3. Square key (1/4 x 1 inch)
9.
Install the pump plate stud into the pump bracket
while installing the hydraulic pump shaft into the
hub assembly.
Note:
The hydraulic pump shaft will touch the
end of the engine PTO shaft
Figure 20
1. Pump bracket
2. Pump plate stud
3. Pump plate
10.
The hub assembly needs to be totally seated
on the shaft.
g003610
4. Setscrew (5/16 x 3/4 inch)
5. Hub assembly
(Figure
20).
g003612
4. Hub assembly
5. Hydraulic pump shaft
6. Setscrew (5/16 x 3/4 inch)
Note:
Verify that there is a gap between the
pump plate and the hub assembly. If there is
no gap, then the hub assembly is not installed
correctly and needs to be seated correctly
(Figure
21).
1. Pump plate
2. Hub assembly
11.
Apply removable thread-locking compound to
the 2 setscrews (5/16 x 3/4 inch) and install them
into the hub assembly to secure the hydraulic
pump shaft
(Figure
9
Installing Hydraulic Lines 3
and 4
Parts needed for this procedure:
1
Hydraulic line number 3
1
Hydraulic line number 4
Procedure
Note:
Install all hydraulic lines loosely first and then
tighten them when all everything is installed.
Use
Figure 22
as a key for identifying the correct
hydraulic lines.
11
Figure 21
3. 1.0 to 3.1 mm (0.040 to
0.122 inch) gap between
hub assembly and pump
plate
20).
g003606
Advertisement
