Installation - Siemens SIREMOBIL Iso-C Troubleshooting Manual

96
I.I. mini-voltage supply
Remove the I.I. mini-voltage supply and lay it down on a suitable surface (control sec-
tion and high voltage section).
See (I.I. mini-voltage supply / p.
Dissipate any residual voltage in the cables by shorting them to ground.
Remove the O-ring and the cap nut from the anode cable.
Remove the plug for the cassette contact.
Disconnect all cables (protective conductor, cable to VIDEOMED DC, etc.) from the I.I.
At the same time, remove the cable ties or the cable clamps.
Pull all the cables inside the C-arm.
I.I. and Compact optics
NOTE
Firmly grasping the I.I., swivel the C-arm so that the I.I. is below and the SIREPHOS is
above.
Place the I.I. carefully on the C-arm flange.
Remove both threaded pins from the I.I. housing.
Lift the I.I. toward the top off the C-arm, turn it around and place it on a suitable surface
(I.I. is standing on the grid).
Remove the retainer clip for attaching the plugs and cable guide from the I.I.
Remove the Compact optics and place them on a dust-free surface.
Reattach the Compact optics and the retainer to the new I.I.
If the "MODULARIS" system or a laser light localizer is present, remove the centering
disk attached above the grid.
Remove the grid. Desolder the wires for the cassette contact.

Installation

Compact optics
NOTE
Reattach the Compact optics to the new I.I.
SIREMOBIL Iso-C
Replacing boards and components
89).
When removing the Compact optics, make sure that no dust
or dirt particles contaminate the I.I. output window.
Do not loosen the eccentric screws
the edge of the Compact optics!
These are used to center the Compact optics with respect to
the I.I. output screen.
When installing the Compact optics and the VIDEOMED DC,
make sure that no dust or dirt particles contaminate the I.I.
output window or the Compact optics.
SPR2-230.840.01.01.02
08.08
((2/Fig. 33 / p.
Page 96 of 148
CS PS SP
100)) on
0
© Siemens, 2008
For internal use only