Angulation Part - Siemens SIREMOBIL Iso-C Troubleshooting Manual

134

Angulation part

Fig. 51:
NOTE
NOTE
If the toothed wheel
perpendicular must be turned prior to installation in one direction until the markings
coincide again when the angulation part is vertical.
Move the C-arm to the 0° position.
Disconnect the cable of the actual value potentiometer.
Loosen the fastening screws of the angulation part.
Replace the angulation part. In doing so, ensure that the markings (black lines) on the
two toothed wheels coincide when the C-arm is perpendicular.
Reconnect the actual value potentiometer cable.
Perform the mechanical settings according to the Startup Instructions, Chapter 6.
SIREMOBIL Iso-C
Replacing boards and components
Only applies to SIREMOBIL Iso-C 3D.
When the angulation part is vertical, the markings on the two
toothed belts must coincide (see
((1/Fig. 51 / p. 134)) was turned several times during transport, the
SPR2-230.840.01.01.02
08.08
(Fig. 51 / p.
Page 134 of 148
CS PS SP
6.30
134)).
© Siemens, 2008
For internal use only