Dose Rate To Be Set At The I.i. Input Screen; Setting The Dose Rate For Survey Format - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Adjustments / Programs

Dose rate to be set at the I.I. input screen:

I.I. type
23 cm (9") I.I.
23 cm (9") I.I.
I.I. type
27 cm (11") I.I.
27 cm (11") I.I.
NOTE

Setting the dose rate for survey format

On the service PC, click the "Update Start" button.
Select the I.I. survey format.
Center the dose measurement chamber on the I.I. input screen and attach.
Use the key
ATE" line).
© Siemens, 2008
For internal use only
I.I. format
Survey 111 nGy/s
Zoom 157 nGy/s *
I.I. format
Survey 85 nGy/s
Zoom 165 nGy/s *
*
For LOW dose rate levels in zoom format:
Due to the maximum possible opening of the TV iris, deviat-
ing dose rate values are acceptable if the dose rate level is
set to LOW in zoom format.
When the dose rate level is set to LOW in zoom format, the
minimum position value (= minimum opening) of the TV iris
may be the same value as in the survey format (opening of TV
iris collimator in zoom format >= opening of TV iris collimator
in survey format).
When the dose rate level is set to LOW in zoom format, the
display "BRIGHTNESS DEVIATION" may show a value
greater than ±3.
If the value shown in "BRIGHTNESS DEVIATION" is greater
than ±3, you must read out and evaluate the position values
of the TV iris collimator when the dose rate level is set to
LOW in both the zoom and survey formats:
(Service PC, Menu Adjustments... / Parameters.../ Doserate
adjustment, Parameter LOW - Zoom format pos. and Parame-
ter LOW Full format pos.)
Acceptable parameter values are: LOW - Zoom format pos. >=
LOW - Full format pos.
Unacceptable parameter values are: LOW - Zoom format pos.
< LOW - Full format pos.
to select the dose rate (LOW / MID / HIGH, shown in the "DOSER-
SPR2-230.840.01.01.02
08.08
Dose rate
LOW MID
185 nGy/s
262 nGy/s
Dose rate
LOW MID
140 nGy/s
262 nGy/s
Page 45 of 148
CS PS SP
45
0
HIGH
370 nGy/s
523 nGy/s
HIGH
280 nGy/s
523 nGy/s
0
SIREMOBIL Iso-C