I.i. Service Position; Moving The I.i. Into The Service Position; Installing The I.i - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Prerequisites

I.I. service position

WARNING
Fig. 8:

Moving the I.I. into the service position

Take the service screws from the kit supplied.
Move the C-arm into the vertical position, with the I.I. below and the SIREPHOS above.
Remove both attachment screws for the I.I. and replace them with the service screws.
Insert the service screws at least 5 turns into the threaded holes of the I.I.
Hold the I.I. firmly and turn the C-arm so that the I.I. is above and the SIREPHOS is
below (Angulation).
Hold the I.I. firmly and carefully remove it from the C-arm. Be careful not to damage the
cable.

Installing the I.I.

Move the C-arm into the vertical position with the I.I. below, the SIREPHOS above.
Holding the I.I. firmly, carefully lift it up. Be careful of the cable.
Holding the I.I. firmly, move the C-arm so that the Sirephos is above and the I.I. is below
(Angulation).
Carefully insert the I.I. into the C-arm. When doing this, be careful not to damage the
cable.
© Siemens, 2008
For internal use only
Risk of injury on mechanical parts!
If these guidelines are not followed, minor to moderate injury,
especially to the hands, can occur.
Follow the notes concerning the C-arm carbon fiber
structure.
SPR2-230.840.01.01.02
08.08
Page 25 of 148
CS PS SP
25
1.6
0
0
SIREMOBIL Iso-C