Safety Information - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Prerequisites

Safety information

WARNING
WARNING
WARNING
© Siemens, 2008
For internal use only
Danger of possibly fatal physical injury and property dam-
age!
Noncompliance can lead to death, physical injury or property
damage.
Follow the product-specific safety information in these
instructions,
Follow the general safety information in the instruc-
tions TD00-000.860.01... and
Follow the general safety information according to
ARTD Part 2.
Electrical voltage!
Noncompliance can lead to death, physical injury or property
damage.
Removing the system covers exposes voltage-con-
ducting parts. To avoid danger, always disconnect the
system from the line voltage before removing the cov-
ers. To do this, pull the power plug or switch the sys-
tem power supply off and secure the power switch
against accidental activation.
If an uninterruptible power supply (UPS) is installed in
the system, the power supply of the UPS must addi-
tionally be switched free of voltage or the voltage out-
put plug must be unplugged.
If service in connection with electrical voltage is
required, the general safety information in instructions
TD00-000.860.01... must be followed.
Electrical voltage!
Noncompliance can lead to death, physical injury or property
damage.
After service is performed on the primary circuit of the
ON/OFF assembly (e.g. replacement of the ON/OFF
assembly or any of its components), the device leak-
age current must be measured and recorded (see sys-
tem manual or logbook).
SPR2-230.840.01.01.02
08.08
Page 11 of 148
CS PS SP
11
1.4
SIREMOBIL Iso-C