Correction Of The 0° Position Of The Slot Diaphragm Display - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Adjustments / Programs
Correction of the 0° position of the slot diaphragm display
NOTE
Select the "Adjustments", "Parameter" menu at the service PC.
Select "Screen display Slot diaphragm" in the Combo box.
Click "Get from Unit".
Select "Rotation 0 degree position".
The parameter in the "Value Actual" field can be changed according to the minimum
and maximum values.
Then click "Set Value".
Click "Put to Unit".
After the SIREMOBIL Iso-C has booted, compare the 0° position of the slot diaphragm
blades to the display on the monitor. If necessary, repeat the programming.
Click "Save to file".
Exit the service program with "Logoff" and "Quit" to save the parameters as a new file to
disk.
© Siemens, 2008
For internal use only
Correct only if the slot diaphragms are shown at an angle of
rotation different from that displayed on the monitor. A cor-
rection of ±10° is possible. Camera rotation and slot dia-
phragm have to be set correctly.
The service PC is connected to the serial interface of the
SIREMOBIL Iso-C.
The service program is started.
SPR2-230.840.01.01.02
08.08
Page 61 of 148
CS PS SP
61
5.9
SIREMOBIL Iso-C