Install ScanRouter V2 Lite according to the flow below.
ScanRouter V2 Lite Installation
Software license agreement
Specify the installation destination
Specify a folder as the
installation destination
Specify a data path
Select a setup type
Restart the computer
Authorization for server access
(Windows NT/2000)
ScanRouter V2 Lite Installation
Install ScanRouter V2 Lite according
to the procedure below.
Make sure that you have all finished
preparing for the server to be installed.
Important
❒ After installation is complete, be
sure to restart the computer. If
ScanRouter V2 Lite is launched be-
fore relaunching the computer, it
may not work normally. In this
case, reinstall ScanRouter V2 Lite.
Note
❒ When you use ScanRouter V2 Lite
in Windows NT/2000, log on Win-
dows with a launch account which
was set in "Account Settings-Win-
dows NT/2000 Only" ⇒ P.3 during
installation.
3. ScanRouter V2 Lite
A
B
C
Installation
Display the "Set up ScanRouter
V2 Lite" dialog box of ScanRouter
V2 Lite.
Select [ScanRouter V2 Lite].
When ScanRouter is installed, se-
lect if ScanRouter data is used.
When "Yes" is selected, conversion
is performed so that address book
data in ScanRouter can be used for
ScanRouter V2 Lite.
Note
❒ Save in advance necessary data
other than the address book
data in ScanRouter in a different
location.
A dialog box for confirming instal-
lation start appears.
7