Connecting To The Ieee1394 Interface (Optional) - Savin IS330DC Setup Manual

Connecting a SCSI cable
A
Switch off the power to the PC
a n d a l l d e v i c e s c o n n e c t e d
through the SCSI interface.
B
Connect the SCSI Connector of
this unit to the SCSI board of the
PC using the SCSI cable.
C
Open the cover at the lower left of
the main unit and check the set-
ting of the 3rd DIP switch.
• If this unit is the last unit of the
daisychain, set the 3rd DIP
switch to OFF.
• If this unit is not the last unit of
the daisychain, set the 3rd DIP
switch to ON.
D
Switch on the power to this unit
and the power of the PC.
For the installation of the neces-
sary software when using this unit,
refer to P.17 "Installing the Scanner
drivers".
Connecting to the IEEE1394
Interface (optional)
Important
❒ Use the cable that comes with the
IEEE1394 Board when using this
unit.
❒ When connecting multiple IEEE1394
compatible devices to multiple PC's,
the operation may become unstable.
Please make sure proper operation
when connecting multiple IEEE1394
compatible devices.
Reference
An IEEE1394 Interface can be used
by installing an optional IEEE1394
Board on this unit. For information
about how to install an IEEE1394
ZDLH110E
Board, refer to P.13 "Installing the
IEEE 1394 Board (IEEE 1394 Inter-
face Board Type S)".
A
Open the cover at the lower left of
the main unit.
Connecting to the PC
ZDLS010E
11
1