Kyocera ECOSYS MA4000cifx Operation Manual page 661

Troubleshooting > Troubleshooting
"Cannot print the specified number of copies." is displayed
Only one copy is available.
• Select [Continue] to continue printing.
• Select [Cancel] to cancel the job.
"Cannot process this job." is displayed
Restricted by the authorization settings.
The job is canceled. Select [End].
Restricted by the job accounting.
The job is canceled. Select [End].
NOTE
If Auto Error Clear is set to [On], the process will resume automatically after a set period of time. For details, refer
to the following:
➡
Auto Error Clear (page 435)
"Cannot read data in this ID card." is displayed
In registration process, the ID card information was not read correctly.
Hold the IC card over the IC card reader again. If the same message is displayed again, the IC card may not be
compatible with this product. Replace it with another IC card.
"Cannot recognize the ID card reader." is displayed
• Check if the USB connector of your IC card reader is correctly connected to the main unit.
• If [USB HOST] in [Interface Block Setting] is set to [Block], change it to [Unblock].
651