Kyocera ECOSYS MA4000cifx Operation Manual page 656

Troubleshooting > Troubleshooting
3
Configure settings for remote operation.
1 [System Menu / Counter] key > [NetworkSettings] > "Connectivity" [Remote Operation] > ON
2 Select from [Off], [Use Password], [Administrator Only]
When you select [Use Password], enter the password in "Password" and "Confirm Password", then select
[OK].
➡
Remote Operation (page 495)
NOTE
You can configure settings for remote operation using Command Center RX.
➡
Command Center RX User Guide
4
Restart the machine.
➡
Restart Entire Device (page 495)
5
Start up the browser.
Specify https: // [Host name of this Machine] and start Command Center RX.
➡
Accessing Command Center RX (page 116)
6
[Device Information / Remote Operation] > [Remote Operation]
7
Click [Start].
NOTE
• If the user is logged in to the device, the permission confirmation screen will be displayed on the
operation panel. Select [Yes].
• If pop-up blocking of the browser occurs during connection of the Remote Operation, select Always allow
pop-ups from https:// [host name], and click [Completed]. Perform [Start] after waiting 1 minute or
more.
When the Remote Operation is started up, the operation panel screen will be displayed on the system
administrator's or user's PC screen.
Executing Remote Operation from VNC Software
1
Display the screen
1 [System Menu / Counter] key > [NetworkSettings] > "Network Settings" [Protocol Settings]
2
Set "Enhanced VNC (RFB)" to On.
➡
Protocol Settings (page 483)
646