Kyocera ECOSYS MA4000cifx Operation Manual page 593

Troubleshooting > Troubleshooting
2
Place the original.
1 Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the leading edge into
the document processor as far as it will go.
NOTE
For details on Original Orientation, refer to the following:
➡
Original Orientation (page 323)
IMPORTANT
Confirm that the original width guides exactly fit the originals. If there is a gap, readjust the original width
guides. The gap may cause the originals to jam.
Ensure that loaded originals do not exceed the level indicator. Exceeding the maximum level may cause
the originals to jam.
Originals with punched holes or perforated lines should be placed with the punched holes or perforated
lines on the right side (so that they will be scanned last).
583