Call Log; Dialing From A Log; Deleting (Single Or All Entries); Set To Defaults - Fortinet FortiFone FON-260i User Manual

Call Log

The phone stores logs to track inbound and outbound calls. There are 3 separate logs that
support 100 entries each. The memory for the logs is circular so if the logs are not cleared when
the capacity reaches 100, the oldest entries are automatically overwritten by new entries.
Missed Calls stores any calls that were unanswered.
Received Calls stores calls that were answered.
Outgoing Calls stores all calls placed from this phone.
To access the Call Logs:
• Press the Up navigation button while the phone is idle.
• Alternatively, press the
• Select 2. Call Log then press the OK button.
• Press

Dialing from a Log

Calls can be made directly from the logs. In the case of the Missed and Received call logs, the
Access Code Prefix is automatically inserted if configured. This is important if you normally are
required to dial a hunt group to access an outside line. For the Outgoing Calls log, the number is
dialed exactly as shown.
To dial from a log:
• While viewing an entry, press the OK button then select Dial.

Deleting (single or all entries)

To delete a single entry:
• While viewing an entry, press the OK button, then select Delete.
• Press the OK button to delete the entry or the Left navigation button to keep the entry.
To delete all entries:
• While viewing an entry, press the OK button, then select Del All.
• Press the OK button to delete the entire log or the Left navigation button to keep the log.

Set to Defaults

If required, the phone configuration can be returned to the original factory default settings.
To return to the default configuration:
• Press the
• Press the OK button to set the phone to factory defaults.
• Move to another parameter with the navigation buttons and continue the session or press
the
Defaulting the phone requires a reboot. When you leave the menu you will receive a reboot
notice. The configuration will not use default values until the phone is rebooted. If looking to
re-register the phone that has been preconfigured as an extension to a FortiVoice system on the
same LAN, reboot the phone again by pressing the
button to reboot the phone.
Returning the phone to factory defaults deletes all previous customized settings.
Configuring your Phone
button, select 5. Directory then press the OK button.
A
to access Missed Calls,
button, select 6. Default and press the OK button.
button to exit the configuration session.
S
to access Received Calls or
button, select 9. Reboot. Press the OK
Page 28
D
to access Outgoing Calls.
FortiFone User Guide for FON-260i