Fluke Datapaq Food Tracker User Manual page 19

Real-time monitoring
Protection (without
thermal barrier)
Sample interval
Memory
Communications
Thermocouple plug shroud
Blanking plugs
Operation
Data collection start
Battery
Battery life
(full charge)
Battery charger
Stop/Start Button Actions
Action
Press GREEN button.
Press RED button.
Press GREEN and RED
buttons together and
hold for 3 s.
Press GREEN button
after downloading data.
FOOD TR ACK ER
Hardwired (serial) telemetry (via communications cable).
Optional TM21 radio-telemetry system available for 8-channel
loggers.
IP67 (submersion to 1 m in water for 30 min) with
thermocouples fitted.
0.5 s to 50 min (standard use – temperature only).
2.0 s to 50 min (radio telemetry – temperature only).
2.0 s to 50 min (temperature and humidity measurement).
1.81 Mb = 16 hours data collection (8 thermocouples and 0.5-s
sample interval).
Serial cable (RS232) – CI1025.
USB cable – CI1026.
To plug thermocouples into the logger in one action,
guaranteeing the correct thermocouple is plugged into the
correct channel (see p. 44).
6-channel plug shroud – CS1130 (supplied as option).
8-channel plug shroud – CS1131 (supplied as standard).
DP1213A (for thermocouple sockets), DP1920A (for humidity-
sensor socket) – inserted into unused channels to give
protection to the connector from dirt, etc., and to provide
water-resistance.
Up to 8 individual runs before download.
Start/stop button, temperature rise/fall, date and time.
Rechargeable NiMH (recharge time 2.5 hours).
Temperature only (0.5-s sample interval) = 120 hours.
Temperature only (10-min sample interval) = 250 hours.
Telemetry (2.0-s sample interval) = 65 hours.
Humidity (2.0-s sample interval) = 120 hours.
CH0070B power-supply unit: input 90–264 V AC, 50–60 Hz,
400 mA.
Results Notes
Starts logging. In telemetry mode also starts sending data.
Stops logging. Data retained in memory. Logger cannot be re-
started until data downloaded. Red LED flashes every
5 s to warn of data in memory. If in telemetry mode
will also send 'end of run' signal to end real-time run.
Turns logger Data retained in memory.
off.
Starts logging. Last re-set conditions (sample interval, probe
selection, etc.) used as default.
19
Hardware