Map Ip Dscp (Interface Configuration) - SMC Networks SMC7724M Management Manual

C L
OMMAND INE

map ip dscp (Interface Configuration)

Use this command to set IP DSCP priority (i.e., Differentiated Services
Code Point priority.) Use the no form to restore the default table.
Syntax
map ip dscp dscp-value cos cos-value
no map ip dscp
• dscp-value - 8-bit DSCP value. (Range: 0-255)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
The list below shows the default priority mapping. Note that all the DSCP
values that are not specified are mapped to CoS value 0.
IP DSCP Value
0
8
10, 12, 14, 16
18, 20, 22, 24
26, 28, 30, 32, 34, 36
38, 40, 42
48
46, 56
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to map IP DSCP value 1 to CoS value
0:
Console(config)#interface ethernet 1/5
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#
3-134
I
NTERFACE
CoS Value
0
1
2
3
4
5
6
7