SMC Networks SMC7724M Management Manual page 304

T
ROUBLESHOOTING
10. After the file has been downloaded, you are prompted with "Update
Image File:" to specify the type of code file. Press <r> for runtime
code, <d> for diagnostic code, or <l> for loader code.
11. Specify a name for the downloaded code file. Filenames are
case-sensitive. The destination file name should not contain slashes
(\ or /), the leading letter of the file name should not be a period (.),
and the length of the file name should be 1 to 31 characters. (Valid
characters: A-Z, a-z, 0-9, ".", "-", "_")
For example, the following screen text shows the download procedure
for a runtime code file:
Select>x
Xmodem Receiving Start ::
Image downloaded to buffer.
Update Image File:r
Runtime Image Filename : v1812.bix
Updating file system.
File system updated.
[Press any key to continue]
12. To set the new downloaded file as the startup file, use the [S]et
Startup File menu option.
13. When you have finished downloading code files, use the [C]hange
Baudrate menu option to change the baud rate of the switch's serial
connection back to 9600 baud.
14. Set your PC's terminal emulation software baud rate back to 9600
baud. Press <Enter> to reset communications with the switch.
15. Press <q> to quit the firmware-download mode and boot the switch.
A-4
[R]untime
[D]iagnostic
[L]oader (Warning: you sure what you are doing?)