SMC Networks SMC7724M Management Manual page 124

C
ONFIGURING THE
Web Interface
Click Rate Limit/Rate Limit Status to enable/disable this feature globally.
Then click Rate Limit Port Configuration or Rate Limit Trunk
Configuration to configure the rate limit for individual ports or trunks.
Command Line Interface
Use the rate-limit input command in Global configuration mode to turn
on rate limit. Use the no form of this command to disable it.
Console#config
Console(config)#rate-limit input
Console(config)#
Use the rate limit input command in Interface Configuration mode to
configure the rate limit on data received on a specific port. Use the no
form of this command to return to default. In the example below, port 1 is
configured to have a rate limit of 10 Mbps.
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 10
Console(config-if)#
2-96
S
WITCH
3-163
3-164