SMC Networks SMC7724M Management Manual page 86

C
ONFIGURING THE
• Mode – Indicates VLAN membership mode for a port. (Configure via
CLI, see page 3-99.)
•
•
Web Interface
Click VLAN/VLAN Trunk Configuration or VLAN Port Configuration.
Fill in the required settings for each interface, click "Apply."
Command Line Interface
This example sets port 1 to accept only tagged frames, assigns PVID 3 as
the native VLAN ID, enables GVRP, sets the GARP timers, and then sets
the switchport mode to hybrid.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#switchport ingress-filtering
Console(config-if)#switchport native vlan 3
Console(config-if)#switchport gvrp
Console(config-if)#garp timer join 10
Console(config-if)#garp timer leave 90
Console(config-if)#garp timer leaveall 2000
Console(config-if)#switchport mode hybrid
Console(config-if)#
2-58
S
WITCH
Trunk – Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port transmits
and receives tagged frames that identify the source VLAN.
Hybrid – Specifies a hybrid VLAN interface. The port may
receive or transmit tagged or untagged frames. Any frames that
are not tagged will be assigned to the default VLAN.
3-69
3-100
3-100
3-101
3-108
3-110
3-110
3-110
3-99